Cannon Downrigger Part 3394002 - CONTROL BOARD ***OBSOLETE***

Write a Review

• 3

  Alternate part

  Posted by Ken on 10th Sep 2021

  Okay, like you I'm bummed that this part is labelled "obsolete" by Cannon. It's not obsolete for those of us with Cannon Mag 10HS. So I purchased 3394006 from Fish307 and wired it per instructions for Mag10STX. The only modification was that I had to snip off the connector provided on the green wire and put onto it instead a 1/4" male spade connector (from hardware store). The PCB is slightly bulkier, and so it took perhaps 5 minutes of fiddling to get it to physically fit into the small space, but it does. And works like a charm. And the relay switch is rated at a higher amperage. Important: Follow the wiring diagram for Cannon Mag 10STX and you'll be fine. DO NOT instead try to match up PCB labels like "J1" "J2" etc. The resistor for the motor output on 3394006 is different than for 3394002. But the motor on the Cannon Mag 10HS is bullet proof.

• 5

  Cannon downrigger control board

  Posted by Michael Maloney on 9th Sep 2020

  It snapped right In. Fished the next day.

• 5

  fits perfect

  Posted by Ron Lefevre on 12th Jun 2020

  works perfect

• 5

  DOWNRIGGER PART

  Posted by Marvin Kisselstein on 14th Aug 2019

  WORKS PERFECT. THANKS FOR THE QUICK TURN AROUND.

• 5

  control board

  Posted by Larry L Larson on 1st Jun 2019

  worked perfect

• 5

  CONTROL BOARD

  Posted by Frank on 29th May 2019

  I hooked it up and it seems to be working fine

• 5

  Thanks!

  Posted by rcandreas@comcast.net on 18th Sep 2018

  The circuit board shipped fast and worked great upon installation

• 5

  easy to install

  Posted by jerry kirk on 20th Jul 2017

  was easy to install and got downrigger working again